| Code |
Function |
| G00 | Rapid positioning |
| G01 | Linear interpolation |
| G02/G03 | Circular interpolation |
| G32 | Tread pitch cutting |
| G90 | Cylindrical or conical cutting 印cle |
| G94 | End surface cutting cycle |
| G92 | Thread cutting c^cle |
| G93 | Tapping fixed cycle |
| G71 | Excircle rough turning cycle |
| G72 | End surface rough turning cycle |
| G73 | Close cutting cycle |
| G74 | End surface deep-hole drilling processing cycle |
| G75 | Outer diameter cutting cycle |
| G76 | Multiple tread cutting cycle |
| G22、 G800 | Fixed cycle |
|
Code |
Function |
| G52 | Part coordinate system setup |
| G31、G311 | Check skip instruction |
| G15、 G16 | Polar coordinate programming |
| 020、G21 | Metric/inch system programming |
| G184、 G185 | Setup tool coordinate system |
| G54-G59 | Work piece coordinate system setup |
| G40、G41、G42 | Tool nose radius compensation instruction |
| G60/G64 | Accurate positioning/continue feed cutting |
| G96/G97 | Constant surges speed cutting |
| G98、G99 | Feed mode |
| G26 | Return to program coordinate |
| G25、G61、G611 | Return to G25 point instruction |
| G28 | Return to reference point |
| G04 | Delay instruction |
| S、M、T | S、M、T function |
| Installation DIM | NJ999TDb/T0c |